Bunn coffee maker manual vp17 series

Disconnect the brewer from the power supply. With a voltmeter, check the voltage across the black and white wires on the tank heater. On VP17B Models the tank heater switch is located on left side of the control panel. Set tank assembly inside the hood on mounting brackets and secure with two screws.

Reconnect the wires to the limit thermostat, tank heater and the control thermostat. Page 18 This manual is also suitable for: Vp17b Vp Vp Print page 1 Print document 19 pages.

Rename the bookmark. Delete bookmark? Cancel Delete. Delete from my manuals? Sign In OR. Don't have an account? Sign up! We're having trouble retrieving real-time pricing. Please try refreshing the page, or contact us at if the problem continues.

Orders can only be shipped in the United States. Your selected catalog region indicates that you are outside the U. Please change your region to North America - U. For international orders please call us at 1 Orders: Tech Services: View all results.

Catalog :. Attention CA residents: Prop 65 Warning. Warning This product can expose you to chemicals including BPA, which are known to the State of California to cause cancer, birth defects, or other reproductive harm.

Server s sold separately. Dimensions: H Spec sheet and manuals. Fetching price Q uanti ty. Add to Cart. Learn more. Pour one pitcher of tap water into the screened area on top of the brewer. After water has stopped flowing from the funnel, allow the water in the tank to reheat to the proper temperature. Empty the decanter. The brewer is now ready for use in accordance with the coffee brewing instructions.

Pour the fresh coffee into the filter and level the bed of grounds by gently shaking. Slide the funnel into the funnel rails. Place an empty dispenser beneath the funnel. When brewing is completed, simply discard the grounds and filter.

The use of a damp cloth rinsed in any mild, non-abrasive, liquid detergent is recommended for cleaning all surfaces on Bunn-O-Matic equipment. Check and clean the sprayhead. The sprayhead holes must always remain open. With the sprayhead removed, insert the deliming spring provided all the way into the sprayhead tube. When inserted properly, no more than two inches of spring should be visible. Saw back and forth five or six times.

NOTE — In hard water areas, this may need to be done daily. It will help prevent liming problems in the brewer and takes less than a minute. A troubleshooting guide is provided to suggest probable causes and remedies for the most likely problems encountered.

If the problem remains after exhausting the troubleshooting steps, contact the Bunn-O-Matic Technical Service Department. Shorting of terminals or the application of external voltages may result in board failure. Board failure will normally be permanent. If an intermittent condition is encountered, the cause will likely be a switch contact or a loose connection at a terminal or crimp. Damage may result if solenoids are energized for more than ten minutes without a supply of water.

This will help to avoid twists and kinks in the tubing. Keep away from combustibles. No power or incorrect voltage to the brewer. Use only replacement part Refer to Service - Tank Heater Switch for testing procedures. See page Refer to Service - Limit Thermostat for testing procedures.

Refer to Service - Control Thermostat for testing procedures. Welcome to ManualMachine.